Email: info@denverhomeevcharger.com
Call: (720) 674-8970
Licensed, vetted electricians for home EV charger installation across the Denver metro, starting with a real load calculation.
Most "EV charger installation" searches actually cover three separate decisions: whether your panel has spare capacity, whether the circuit needs to be dedicated, and which charger fits how you’ll actually use it. Skipping the first question is the single most common reason installs run over budget — a homeowner gets a flat-rate quote for the charger itself, then finds out mid-job that the panel can’t support the new circuit without an upgrade.
We start every home installation the same way: a licensed electrician performs a load calculation against your home’s existing electrical demand and panel capacity (a 100A panel with several large appliances already on it behaves very differently than a 200A panel in a newer build), then scopes the actual work — new circuit, panel upgrade if needed, and the charger installation itself — before any pricing is finalized.
An EV charger typically needs a dedicated 240V circuit, commonly sized at 40-60 amps depending on the charger and your home’s wiring distance. Whether your panel has that capacity available — without exceeding its rated total load — is a code question, not a guess, which is why a load calculation happens before the installation quote is finalized, not after.
A real calculation of your home’s electrical capacity, not an estimate from the driveway.
A dedicated 240V circuit sized correctly for your charger and wire run.
Correct mounting height, GFCI protection where required, and full setup.
Handled as part of the job in most Denver-metro jurisdictions.
A straightforward Level 2 installation on a panel with available capacity typically runs $1,000-$2,500 all-in — equipment, labor, and permit. If your panel needs an upgrade, that adds a separate cost on top. See our full cost breakdown for exact ranges by scenario.
Every electrician in our network is independently licensed in Colorado, insured, and checked against a real installation history before we route a lead to them. We match your job to an electrician suited to it — a simple plug-in and a full panel upgrade aren’t the same job, and we don’t treat them like they are.
Request a free quote and we’ll match you with a licensed local electrician.
Request a free quote and tell us about your home and your charger.
We match you with a licensed local electrician suited to your job.
They perform a load calculation and confirm the real scope of work.
The installation happens, permitted and inspected per your city’s requirements.
You’re left with a documented, code-compliant install — not a verbal "should be fine."
In most Denver-metro cities, yes — a new dedicated circuit requires an electrical permit and inspection. Your matched electrician handles this as part of the job.
That’s what the load calculation is for — if an upgrade is needed, you’ll know before the installation starts, not after.
A straightforward Level 2 installation usually takes a few hours in a single visit. A panel upgrade adds additional time and, in some cases, a second visit for inspection.